1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DRAIN BRAKE FLUID
If brake fluid leaks onto any painted surface, immediately wash it off.
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
28800
4.REMOVE BATTERY
74431
5.REMOVE BATTERY TRAY
74410
6.REMOVE BATTERY CARRIER ASSEMBLY
47150
7.REMOVE PROPORTIONING VALVE ASSEMBLY
Using a 10 mm union nut wrench, disconnect the 6 brake tubes from the proportioning valve assembly and brake tube way.
Remove the 2 bolts and proportioning valve bracket with the proportioning valve assembly from the body.
Using a 10 mm union nut wrench, remove the 6 union nuts and 3 brake tubes from the proportioning valve assembly and brake tube way.
Remove the 2 nuts and proportioning valve assembly from the proportioning valve bracket.