47150
1.INSTALL PROPORTIONING VALVE ASSEMBLY
Install the proportioning valve assembly to the proportioning valve bracket with the 2 nuts.
Using a 10 mm union nut wrench, install the 3 brake tubes to the proportioning valve assembly and brake tube way with the 6 union nuts.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Install the proportioning valve bracket with the proportioning valve assembly with the 2 bolts in the order shown in the illustration.
Using a 10 mm union nut wrench, connect the 6 brake tubes to the proportioning valve assembly and brake tube way.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
74410
2.INSTALL BATTERY CARRIER ASSEMBLY
74431
3.INSTALL BATTERY TRAY
28800
4.INSTALL BATTERY
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
6.BLEED BRAKE LINE