Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
1.REMOVE REAR WHEEL
2.DRAIN BRAKE FLUID
If brake fluid leaks onto any painted surface, immediately wash it off.
58910C
3.REMOVE REAR CONSOLE BOX ASSEMBLY (w/ Console Box Lid)
58910C
4.REMOVE REAR CONSOLE BOX ASSEMBLY (w/o Console Box Lid)
5.LOOSEN PARKING BRAKE CABLE
42403
6.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY
Release the parking brake and remove the rear brake drum sub-assembly.
If the rear brake drum sub-assembly cannot be removed easily, perform the following procedure.
|
Contract |
Remove the shoe adjusting hole plug.
Insert a screwdriver through the hole into the backing plate, and hold the automatic adjust lever away from the adjuster.
Using another screwdriver, contract the brake shoe by turning the adjusting bolt.
7.REMOVE REAR BRAKE STRUT KIT
| *1 | Wheel Cylinder Boot |
| *2 | Tension Spring |
Using SST, separate the tension spring from the rear brake shoe (front).
Do not damage the wheel cylinder boot.
Using SST, remove the shoe hold down spring cup, shoe hold down spring, shoe hold down spring pin and rear brake shoe (front).
Remove the shoe tension spring from the rear brake shoe (front) and rear brake shoe (rear).
Using SST, remove the shoe hold down spring cup, shoe hold down spring, shoe hold down spring pin and rear brake shoe (rear).
Remove the tension spring and rear brake strut kit from rear brake shoe (rear).
Using needle-nose pliers, separate the No. 3 parking brake cable assembly from the rear brake parking brake shoe lever sub-assembly.
8.REMOVE REAR BRAKE AUTOMATIC ADJUST LEVER
Remove the rear brake automatic adjust lever tension spring and rear brake automatic adjust lever from the rear brake shoe (front).
9.REMOVE REAR BRAKE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY
Using a screwdriver, remove the C-washer and rear brake parking brake shoe lever sub-assembly from the rear brake shoe (rear).
47570
10.REMOVE REAR WHEEL BRAKE CYLINDER ASSEMBLY
Using a 10 mm union nut wrench, disconnect the brake tube from the rear wheel brake cylinder assembly.
Remove the bolt and rear wheel brake cylinder assembly from the backing plate.