Use the same procedure for both the LH and RH side.
The procedure described below is for the LH side.
1.REMOVE REAR COMBINATION LIGHT ASSEMBLY
62506C
2.REMOVE QUARTER PILLAR COVER SUB-ASSEMBLY
|
Protective Tape |
Apply protective tape to the vehicle body in the area around the quarter pillar cover sub-assembly.
Remove the quarter garnish moulding.
Using a moulding remover, disengage the 3 clips and pin in the order shown in the illustration.
Disengage the 2 guides, and slide the quarter pillar cover sub-assembly in the direction shown by the arrow in the illustration and remove it.
Using a clip remover, remove the 2 clips.
Remove the 3 clips.