FREEZE FRAME DATA
Whenever a DTC is detected, the skid control ECU (brake actuator assembly) stores the current vehicle (sensor) state as Freeze Frame Data.
The skid control ECU (brake actuator assembly) stores the number of times (maximum: 31) the ignition switch has been turned from off to ON since the last time the ABS was activated.
However, if the vehicle is stopped or at a low speed (7 km/h (4.3 mph) or less), or if a DTC is detected, the skid control ECU (brake actuator assembly) will stop counting the number.
Freeze Frame Data at the time the ABS operates:
The skid control ECU (brake actuator assembly) stores and updates data whenever the ABS system operates.
When the ECU stores data at the time a DTC is detected, the data stored during ABS operation is cleared.
Freeze Frame Data at the time a DTC is detected:
When the skid control ECU (brake actuator assembly) stores data at the time a DTC is detected, no updates will be performed until the data is cleared.
CHECK FREEZE FRAME DATA
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.
Select a DTC to display its Freeze Frame Data.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Elapsed Time after Freeze Trigger | Elapsed time after freeze trigger | Min.: 0 msec
Max.: 500 msec |
- | - |
| Number of IG ON | Number of operations of ignition switch being turned to ON after storing Freeze Frame Data | 0 to 31 | - | - |
| Stop Light SW | Stop light switch | OFF or ON | OFF: Brake pedal released
ON: Brake pedal depressed |
- |
| Parking Brake SW | Parking brake switch | OFF or ON | OFF: Parking brake released
ON: Parking brake applied |
- |
| Operated System | Operated system status | Non, ABS, VSC, TRC, BA, HAB, Fail, PBA, PB, HA-CTRL, Sys | Non: No operation activated
ABS: ABS activated Fail: Fail safe mode activated Sys: System prohibit activated |
- |
| Forward and Rearward G | Forward and backward G | Min.: -25.10 m/s2
Max.: 24.90 m/s2 |
- | for CVT: Changes continuously during deceleration/acceleration.
except CVT: The item is displayed on the GTS but not used. |
| FR Wheel Speed | FR wheel speed sensor reading | Min.: 0 km/h (0 mph)
Max.: 326 km/h (202 mph) |
0 km/h: Vehicle stopped | When driving at constant speed:
No large fluctuations |
| FL Wheel Speed | FL wheel speed sensor reading | Min.: 0 km/h (0 mph)
Max.: 326 km/h (202 mph) |
0 km/h: Vehicle stopped | When driving at constant speed:
No large fluctuations |
| RR Wheel Speed | RR wheel speed sensor reading | Min.: 0 km/h (0 mph)
Max.: 326 km/h (202 mph) |
0 km/h: Vehicle stopped | When driving at constant speed:
No large fluctuations |
| RL Wheel Speed | RL wheel speed sensor reading | Min.: 0 km/h (0 mph)
Max.: 326 km/h (202 mph) |
0 km/h: Vehicle stopped | When driving at constant speed:
No large fluctuations |
| Vehicle Speed | Maximum wheel speed sensor reading | Min.: 0 km/h (0 mph)
Max.: 326 km/h (202 mph) |
Actual vehicle speed | Speed indicated on speedometer |
| Vehicle Speed Grade | Vehicle speed grade | Min.: -25.10 m/s2
Max.: 24.90 m/s2 |
0 m/s2: Vehicle stopped | During driving: Changes in proportion with vehicle acceleration/deceleration |
| IG1 Voltage Value | IG1 voltage value | Min.: 0.00 V
Max.: 20.00 V |
- | Changes in proportion to battery voltage |
CLEAR FREEZE FRAME DATA
Clearing the DTC will also clear the Freeze Frame Data.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Clear the DTC and Freeze Frame Data.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR