Connecting terminals TC and CG of the DLC3 causes the ECU to display the DTC by blinking the ABS warning light and slip indicator light.
When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION
Check if CAN communication system DTCs are output.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
| Proceed to | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
| *1 | DLC3 |
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| F16-13 (TC) -F16-4 (CG) | Ignition switch ON | 11 to 14 V |
| Result | Proceed to |
|---|---|
| NG | A |
| OK | B |
A
B
Turn the ignition switch off.
Disconnect the F131 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F16-13 (TC) - F131-19 (TC) | Always | Below 1 Ω |
| F16-13 (TC) or F131-19 (TC) - Body ground | Always | 10 kΩ or higher |
Reconnect the F131 ECM connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F16-4 (CG) -Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | DLC3 |
Turn the ignition switch off.
Using SST, connect terminals TC and CG of the DLC3.
Turn the ignition switch to ON.
Check that the malfunction indicator lamp is blinking.
| Result | Proceed to |
|---|---|
| MIL is blinking | A |
| MIL is not blinking | B |
A
B
Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING