Home › Power Source / Network › 2NR-FE BATTERY / CHARGING › CHARGING SYSTEM › from 2016.04
RM30M0E _57 Power Source / Network _052956 2NR-FE BATTERY / CHARGING _0256535 CHARGING SYSTEM C

2NR-FE BATTERY / CHARGING  CHARGING SYSTEM  P161A  Lost Communication with Alternator  


DESCRIPTION

The ECM and generator with regulator assembly detect reception errors respectively.

The generator with regulator assembly reception error detected by the generator with regulator assembly is sent to the ECM via LIN communication. If an error occurs in the ECM or generator with regulator assembly, the ECM determines there is a LIN communication error and stores this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area
P161A Lost Communication with Alternator Generator with regulator assembly or ECM communication stop for about 17 minutes or more with the ignition switch to ON.
(1 trip detection logic)
·

Wire harness and connector

·

Generator with regulator assembly

·

ECM



WIRING DIAGRAM

A340530E24
1.51,3.167 5.177,3.365 3.667,0.198 10 false : LIN Communication Line 4.948,2.521 6.177,2.719 1.229,0.198 10 false B47 1.708,2.208 2.167,2.406 0.458,0.198 10 false B36 1.698,2.365 4.448,2.563 2.75,0.198 10 false Generator with Regulator Assembly 4.885,1.708 5.344,1.906 0.458,0.198 10 false LIN 3.083,1.531 3.24,1.729 0.156,0.198 10 false 2 4.646,1.531 4.958,1.729 0.313,0.198 10 false 16 2.792,1.698 3.25,1.896 0.458,0.198 10 false LIN 4.948,2.677 6.177,2.875 1.229,0.198 10 false ECM

PROCEDURE

1.CHECK CHARGING SYSTEM

Result:
Result
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (ECM - GENERATOR WITH REGULATOR ASSEMBLY)

NG

REPAIR OR REPLACE CHARGING SYSTEM

2.CHECK HARNESS AND CONNECTOR (ECM - GENERATOR WITH REGULATOR ASSEMBLY)
a.

Disconnect the B47 ECM connector.


b.

Disconnect the B36 generator with regulator assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
B47-16 (LIN) - B36-2 (LIN) Always Below 1 Ω
B47-16 (LIN), B36-2 (LIN) - body ground Always 10 kΩ or higher



d.

Reconnect the B36 generator with regulator assembly connector.


e.

Reconnect the B47 ECM connector.


Result:
Proceed to
OK
NG



OK

REPLACE GENERATOR WITH REGULATOR ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR