Home › Power Source / Network › 2NR-FE BATTERY / CHARGING › GENERATOR › from 2016.04
RM30M0E _57 Power Source / Network _052956 2NR-FE BATTERY / CHARGING _0262395 GENERATOR A

2NR-FE BATTERY / CHARGING  GENERATOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 16361A 3.REMOVE FAN AND GENERATOR V BELT

Hide 15301 5.REMOVE OIL LEVEL DIPSTICK SUB-ASSEMBLY

A377452

a.

Remove the oil level dipstick sub-assembly from the oil level dipstick guide.


Hide 11452 6.REMOVE OIL LEVEL DIPSTICK GUIDE

A377453

a.

Disengage the clamp to disconnect the engine wire from the oil level dipstick guide.


b.

Remove the bolt and oil level dipstick guide from the camshaft housing sub-assembly and oil pan sub-assembly.


c.

Remove the O-ring from the oil level dipstick guide.


Hide 17167 7.REMOVE NO.1 EXHAUST MANIFOLD HEAT INSULATOR

a.
A313661

Remove the 2 nuts, bolt and No. 1 exhaust manifold heat insulator from the exhaust manifold converter sub-assembly.


Hide 82121 8.DISCONNECT ENGINE WIRE

a.
A314324

Disengage the 3 clamps to disconnect the engine wire from the upper radiator support.


b.
A314327

Remove the terminal cap.


c.
A314418

Disconnect the generator with regulator assembly connector.


d.

Disengage the 2 clamps to disconnect the engine wire from the wiring harness clamp bracket.


e.

Remove the nut to disconnect the engine wire from the terminal B.


Hide 9.REMOVE WIRING HARNESS CLAMP BRACKET

a.
A314419

Remove the bolt and wiring harness clamp bracket from the generator with regulator assembly.


Hide 27060 10.REMOVE GENERATOR WITH REGULATOR ASSEMBLY

a.
A314420

Remove the 2 bolts and generator with regulator assembly from the cylinder block sub-assembly.