Home › Drivetrain › K312 CVT › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM › 2016.04–2017.10
RM30M0E _52 Drivetrain _052969 K312 CVT _0256556 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM L

K312 CVT  CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM  PRECAUTION  


IGNITION SWITCH EXPRESSION


HINT:

The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression Ignition Switch (Position) Engine Switch (Condition)
Ignition Switch off Off Off (Lock)
Ignition Switch ON ON On (IG)
Ignition Switch ACC ACC On (ACC)
Engine Start START On (Start)



PRECAUTION


NOTICE:
·

If the Continuously Variable Transaxle (CVT) assembly or ECM is replaced, make sure to perform Reset Memory.

·

Performing Reset Memory will clear the learned values of the yaw rate and acceleration sensor (Deceleration Sensor Zero Point Calibration) and the CVT oil pressure (CVT Oil Pressure Calibration). Make sure to perform Reset Memory, Deceleration Sensor Zero Point Calibration, and CVT Oil Pressure Calibration if any of the parts in the following table have been replaced.

Click hereDrivetrain>K312 CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION

Replaced Part
·

Continuously variable transaxle assembly

·

ECM

·

Oil pressure sensor

·

Airbag ECU assembly (Yaw rate and acceleration sensor)*1

·

Brake actuator assembly (Skid control ECU)*2

·

Deceleration sensor assembly*2



*1: w/ VSC

*2: w/o VSC





HANDLING PRECAUTIONS


CAUTION:

When using compressed air, always aim away from yourself to prevent CVT fluid from spraying on your face.



NOTICE:
·

Before removing components from the transaxle, clean off any sand, dirt or other foreign matter present on the exterior of the transaxle. Make sure that foreign matter does not contaminate the inside of the transaxle when parts are removed or installed, or during disassembly and reassembly of the transaxle.

·

When disassembling light alloy parts such as the transaxle case, do not pry them with a screwdriver or similar tool. Instead, tap the parts with a plastic hammer to separate them.

·

Do not wear cloth gloves or use cloth to handle parts during removal, disassembly, or installation of the transaxle. Instead, wear synthetic gloves to prevent cloth fiber from entering the transaxle.

·

Removed parts should be arranged in order and care should be taken to prevent dust contamination.

·

Apply Toyota Genuine CVT Fluid FE to all sliding surfaces and rotating parts.

·

Before installing O-rings and oil seal rings, coat them with Toyota Genuine CVT Fluid FE and be sure not to damage them.

·

Be careful not to damage the sealing surfaces of components, because damage to these surfaces can cause oil leaks.

·

Before applying seal packing, remove all of the old seal packing and thoroughly clean the surfaces with a non-residue solvent.

·

Use of Toyota Genuine CVT Fluid FE is recommended.

·

Do not subject parts such as sensors to any impacts. Replace parts with new ones if they are dropped or subjected to a severe impact.