The ECM uses the shift solenoid valve SLU to perform forward and reverse clutch control or lock-up clutch control.
| *1 | Spool Valve | *2 | Sleeve |
| *3 | Solenoid Coil | - | - |
| *a | Hydraulic Pressure | *b | Current Flow to Solenoid |
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P2759 | Torque Converter Clutch Pressure Control Solenoid Control Circuit Electrical (Shift Solenoid Valve SLU) | While the vehicle is driven, there is an open or short in the shift solenoid valve SLU circuit for 1 second or more (1 trip detection logic). | ·
Wire harness or connector ·
Continuously variable transaxle assembly (Shift solenoid valve SLU) ·
ECM |
Comes on | DTC stored |
This DTC indicates an open or short in the shift solenoid valve SLU circuit. If there is an open or short in the shift solenoid valve SLU circuit, the ECM detects the malfunction, illuminates the MIL and stores this DTC.
Perform initialization after replacing any parts related to the continuously variable transaxle system.
Click hereDrivetrain>K312 CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION
Check that no DTCs are stored after performing initialization.
Click hereDrivetrain>K312 CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DTC CHECK / CLEAR
| *a | Component without harness connected
(Transmission Wire) |
Disconnect the B53 transmission wire connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 6 (SLU+) - 13 (SLU-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| 6 (SLU+) - Body ground and other terminals | Always | 10 kΩ or higher |
| 13 (SLU-) - Body ground and other terminals | Always | 10 kΩ or higher |
Connect the B53 transmission wire connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the B48 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B48-2 (SLU+) - B48-1 (SLU-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| B48-2 (SLU+) - Body ground and other terminals | Always | 10 kΩ or higher |
| B48-1 (SLU-) - Body ground and other terminals | Always | 10 kΩ or higher |
Connect the B48 ECM connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the ECM.
Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>ECM>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Replace the continuously variable transaxle assembly.
Click hereDrivetrain>K312 CVT>CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY>COMPONENTS
| Proceed to |
|---|
| NEXT |
NEXT