1.REMOVE FRONT DRIVE SHAFT ASSEMBLIES
43420H
2.REMOVE FRONT DRIVE SHAFT OIL SEAL LH
Using SST, remove the front drive shaft oil seal LH from the continuously variable transaxle assembly.
Do not damage the front drive shaft oil seal LH contact surface of the continuously variable transaxle assembly.
43410M
3.REMOVE FRONT DRIVE SHAFT OIL SEAL RH
Using SST, remove the front drive shaft oil seal RH from the continuously variable transaxle assembly.
Do not damage the front drive shaft oil seal RH contact surface of the continuously variable transaxle assembly.
43420H
4.INSTALL FRONT DRIVE SHAFT OIL SEAL LH
| *a | Drive in Depth |
Using SST and a hammer, tap in a new front drive shaft oil seal LH to the continuously variable transaxle assembly.
2.6 to 3.6 mm (0.103 to 0.141 in.)
Be sure to install the front drive shaft oil seal LH in the correct direction.
Make sure to install the front drive shaft oil seal LH as specified, otherwise malfunctions such as an fluid leak will occur.
Apply MP grease to the lip of the front drive shaft oil seal LH.
43410M
5.INSTALL FRONT DRIVE SHAFT OIL SEAL RH
| *a | Drive in Depth |
Using SST and a hammer, tap in a new front drive shaft oil seal RH to the continuously variable transaxle assembly.
-0.5 to 0.5 mm (-0.0196 to 0.0196 in.)
Be sure to install the front drive shaft oil seal RH in the correct direction.
Make sure to install the front drive shaft oil seal RH as specified, otherwise malfunctions such as an fluid leak will occur.
Apply MP grease to the lip of the front drive shaft oil seal RH.
6.INSTALL FRONT DRIVE SHAFT ASSEMBLIES