Home › Drivetrain › K411 CVT › OIL COOLER › from 2016.04
RM30M0E _52 Drivetrain _052750 K411 CVT _0259919 OIL COOLER A

K411 CVT  OIL COOLER  INSTALLATION  


PROCEDURE

Hide 33493C 1.INSTALL TRANSMISSION OIL COOLER

a.

Apply a light coat of Toyota Genuine CVT fluid FE to 2 new O-rings and install them to the transmission oil cooler.


b.

Install the transmission oil cooler to the continuously variable transaxle assembly with the 3 bolts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)

NOTICE:

Make sure that the O-rings are not damaged or do not jump out of position during installation.



Hide 16260 2.CONNECT WATER BY-PASS HOSE ASSEMBLY

a.
C288547C01
2.167,2.698 2.292,2.958 true 1.135,2.135 1.448,2.292 0.313,0.156 10 false *a 1.875,3.083 2.188,3.24 0.313,0.156 10 false *b 2.375,2.573 2.688,2.729 0.313,0.156 10 false *c 2.24,2.979 2.552,3.135 0.313,0.156 10 false *d 0.938,0.385 1.094,0.583 0.156,0.198 10 false A 2.375,0.135 2.531,0.333 0.156,0.198 10 false A
*a View A
*b Front of Vehicle
*c Left of Vehicle
*d Blue Mark


Connect the 2 water by-pass hoses to the transmission oil cooler and slide the 2 hose clips to secure them as shown in the illustration.

NOTICE:
·

Fully insert the 2 water by-pass hoses until the 2nd rib on each transmission oil cooler pipe.

·

Perform the installation with the hose clips at the correct directions.




Hide 4.ADD CONTINUOUSLY VARIABLE TRANSAXLE FLUID

Hide 6.INSPECT FOR CONTINUOUSLY VARIABLE TRANSAXLE FLUID LEAK

Hide 51442C 7.INSTALL ENGINE UNDER COVER LH (w/o Metal Type Under Cover)

Hide 51405A 8.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)

Hide 51451A 9.INSTALL CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)