Home › Drivetrain › K411 CVT › REVOLUTION SENSOR › from 2016.04
RM30M0E _52 Drivetrain _052750 K411 CVT _0259920 REVOLUTION SENSOR A

K411 CVT  REVOLUTION SENSOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 17880 3.REMOVE AIR CLEANER HOSE ASSEMBLY

Hide 17801 5.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 17701 6.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 89413P 10.REMOVE TRANSMISSION REVOLUTION SENSOR (NIN)

a.
C288551

Disconnect the transmission revolution sensor (NIN) connector.


b.

Remove the bolt and transmission revolution sensor (NIN) from the continuously variable transaxle assembly.


c.

Remove the O-ring from the transmission revolution sensor (NIN).


Hide 89413M 11.REMOVE TRANSMISSION REVOLUTION SENSOR (NOUT)

a.
C288552C01
0.76,1.229 1.073,1.354 false 0.604,1.125 0.917,1.281 0.313,0.156 10 false *1
*1 Transmission Revolution Sensor Spacer


Disconnect the transmission revolution sensor (NOUT) connector.


b.

Remove the bolt, transmission revolution sensor (NOUT) and transmission revolution sensor spacer from the continuously variable transaxle assembly.


c.

Remove the O-ring from the transmission revolution sensor (NOUT).


Hide 89413N 12.REMOVE TRANSMISSION REVOLUTION SENSOR (NT)

a.
C288550

Disconnect the transmission revolution sensor (NT) connector.


b.

Remove the bolt and transmission revolution sensor (NT) from the continuously variable transaxle assembly.


c.

Remove the O-ring from the transmission revolution sensor (NT).