Home › Engine / Hybrid System › 1NR-FE COOLING › COOLING FAN MOTOR › 2016.04–2017.10
RM30M0E _51 Engine / Hybrid System _053564 1NR-FE COOLING _0259960 COOLING FAN MOTOR A

1NR-FE COOLING  COOLING FAN MOTOR  INSTALLATION  


PROCEDURE

Hide 16363 1.INSTALL COOLING FAN MOTOR

a.

Install the cooling fan motor to the fan shroud with the 3 screws.

Torque:
3.9 N*m (40 kgf*cm, 35 in.*lbf)


Hide 16361 2.INSTALL FAN

a.

Install the fan to the cooling fan motor with the nut.

Torque:
6.3 N*m (64 kgf*cm, 56 in.*lbf)


Hide 16711 3.INSTALL FAN SHROUD

a.
A381287

Engage the 3 guides and 2 claws to install the fan shroud to the radiator assembly.

NOTICE:

Do not apply any excessive force to the radiator assembly when installing the fan shroud.



b.

Engage the 3 clamps to connect the wire harness to the fan shroud.


c.

Connect the cooling fan motor connector.


Hide 4.INSTALL WIRE HARNESS CLAMP BRACKET

a.

Install the wire harness clamp bracket to the cylinder head sub-assembly with the bolt.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


b.

Engage the clamp to connect the wire harness to the wire harness clamp bracket.


c.

Engage the 2 clamps to connect the air fuel ratio sensor wire to the wire harness clamp bracket.


d.

Connect the air fuel ratio sensor connector.


Hide 16571C 5.CONNECT NO. 1 RADIATOR HOSE

Hide 6.CONNECT RADIATOR RESERVOIR TANK HOSE