Be sure that the ignition switch is off if you work near the electric cooling fans or radiator grille. With the ignition switch ON, the electric cooling fans may automatically start to run if the engine coolant temperature is high and/or the air conditioning is on (w/ air conditioning system).
1.DRAIN ENGINE COOLANT
2.DISCONNECT RADIATOR RESERVOIR TANK HOSE
16571C
3.DISCONNECT NO. 1 RADIATOR HOSE
4.REMOVE WIRE HARNESS CLAMP BRACKET
Disconnect the air fuel ratio sensor connector.
Disengage the 2 clamps to separate the air fuel ratio sensor wire from the wire harness clamp bracket.
Disengage the clamp to disconnect the wire harness from the wire harness clamp bracket.
Remove the bolt and wire harness clamp bracket from the cylinder head sub-assembly.
16711
5.REMOVE FAN SHROUD
Disconnect the cooling fan motor connector.
Disengage the 3 clamps to disconnect the wire harness from the fan shroud.
Disengage the 2 claws and 3 guides to remove the fan shroud from the radiator assembly.
Do not apply any excessive force to the radiator assembly when removing the fan shroud.
16361
6.REMOVE FAN
Remove the nut and fan from the cooling fan motor.
16363
7.REMOVE COOLING FAN MOTOR
Remove the 3 screws and cooling fan motor from the fan shroud.