1.INSPECT FUEL CUT OPERATION
Start and warm up the engine.
Turn all the electrical systems and the A/C off.
Open the throttle valve and keep the engine speed at 3500 rpm.
| *1 | Fuel Injector Assembly |
| *a | Sound Scope |
Use a sound scope to check for injector operating sounds.
Check that when the accelerator pedal is released, fuel injector assembly operating sounds stop momentarily and then resume.
| Item | Specified Condition |
|---|---|
| Fuel injection restart engine speed | 1000 rpm |
If the result is not as specified, check the fuel injector assemblies, wire harness and ECM.
2.VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS
Inspect the hoses and gaskets for scratches, cracks and air/oil leaks from the connecting parts.
If the hoses or gaskets are damaged or some of the connections are loose, they may cause an engine stall or malfunction.
3.INSPECT EVAPORATIVE EMISSION CONTROL SYSTEM
Start the engine.
Disconnect the No. 1 fuel vapor feed hose.
Click hereEngine / Hybrid System>1NR-FE EMISSION CONTROL>PURGE VALVE>REMOVAL
Connect the GTS to the DLC3.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VSV for Evap Control.
| Tester Display |
|---|
| Activate the VSV for Evap Control |
Check that a vacuum occurs at the purge VSV port.
If vacuum does not occur, check the following items.
Purge VSV (for canister purge)
Clogging in the fuel vapor feed hose connecting the intake air surge tank and purge VSV
Voltage from the ECM PRG terminal
Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>SFI SYSTEM>TERMINALS OF ECM
Exit the Active Test mode.
Connect No. 1 fuel vapor feed hose.
Click hereEngine / Hybrid System>1NR-FE EMISSION CONTROL>PURGE VALVE>INSTALLATION
Enter the following menus: Powertrain / Engine and ECT / Data List / EVAP Purge VSV.
| Tester Display |
|---|
| EVAP (Purge) VSV |
Warm up the engine and drive the vehicle.
Confirm that the purge VSV opens.
If the result is not as specified, replace the purge VSV, wire harness or ECM.