Home › Engine / Hybrid System › 1NR-FE EMISSION CONTROL › PURGE VALVE › from 2016.04
RM30M0E _51 Engine / Hybrid System _053552 1NR-FE EMISSION CONTROL _0259976 PURGE VALVE A

1NR-FE EMISSION CONTROL  PURGE VALVE  INSTALLATION  


PROCEDURE

Hide 25860 1.INSTALL PURGE VSV (PURGE VALVE)

a.

Insert the purge VSV into the air cleaner hose assembly to install it.


b.
A381828C01
2.052,0.823 2.313,0.708 false 1.438,0.99 1.594,1.188 0.156,0.198 10 false A 1.875,0.792 2.188,0.99 0.313,0.198 10 false *b 1.927,0.198 2.24,0.396 0.313,0.198 10 false *a 2.135,0.385 2.469,0.573 0.333,0.188 10 false 30° 2.438,0.385 2.75,0.594 0.313,0.208 10 false 30° 2.406,0.167 2.719,0.365 0.313,0.198 10 false *c
*a View A
*b Hose Paint Mark
*c Top of Vehicle


Connect the No. 2 fuel vapor feed hose to the purge VSV.

NOTICE:

Perform the installation with the No. 2 fuel vapor feed hose at the correct angle.



c.
A381829C01
1.958,0.906 2.333,0.771 false 0.563,1.25 0.719,1.448 0.156,0.198 10 false A 1.854,0.354 2.167,0.552 0.313,0.198 10 false *a 1.802,0.854 2.115,1.052 0.313,0.198 10 false *b 2.396,0.292 2.708,0.49 0.313,0.198 10 false *c 2.146,0.479 2.542,0.74 0.396,0.26 10 false 30° 2.448,0.479 2.792,0.729 0.344,0.25 10 false 30°
*a View A
*b Hose Paint Mark
*c Rear Side of Vehicle


Connect the No. 1 fuel vapor feed hose to the purge VSV and slide the hose clip to secure it.

NOTICE:

Perform the installation with the No. 1 fuel vapor feed hose at the correct angle.



d.

Engage the clamp to connect the wire harness to the purge VSV.


e.

Connect the purge VSV connector.