Home › Drivetrain › K312 CVT › REVOLUTION SENSOR › from 2016.04
RM30M0E _52 Drivetrain _052969 K312 CVT _0259993 REVOLUTION SENSOR A

K312 CVT  REVOLUTION SENSOR  INSTALLATION  


PROCEDURE

Hide 89413M 1.INSTALL TRANSMISSION REVOLUTION SENSOR (NOUT)

a.

Apply Toyota Genuine CVT fluid FE to a new O-ring, and install it to the transmission revolution sensor (NOUT).

NOTICE:

Be careful not to damage or twist the O-ring.



b.

Install the transmission revolution sensor (NOUT) to the continuously variable transaxle assembly with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


c.

Connect the transmission revolution sensor (NOUT) connector.


Hide 89413P 2.INSTALL TRANSMISSION REVOLUTION SENSOR (NIN)

a.

Apply Toyota Genuine CVT fluid FE to a new O-ring, and install it to the transmission revolution sensor (NIN).

NOTICE:

Be careful not to damage or twist the O-ring.



b.

Install the transmission revolution sensor (NIN) to the continuously variable transaxle assembly with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


c.

Connect the transmission revolution sensor (NIN) connector.


Hide 3.INSPECT FOR CONTINUOUSLY VARIABLE TRANSAXLE FLUID LEAK

Hide 51442C 4.INSTALL ENGINE UNDER COVER LH (w/o Metal Type Under Cover)

Hide 51405A 5.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)

Hide 51451A 6.INSTALL CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)