Home › Drivetrain › K312 CVT › OIL PRESSURE SENSOR › from 2016.04
RM30M0E _52 Drivetrain _052969 K312 CVT _0259994 OIL PRESSURE SENSOR A

K312 CVT  OIL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89637K 1.INSTALL OIL PRESSURE SENSOR

a.

Apply Toyota Genuine CVT fluid FE to a new O-ring of the oil pressure sensor.

NOTICE:

If reusing the oil pressure sensor, check that the O-ring is not damaged.



b.
C321418C02
1.813,0.365 0.875,0.25 true 0.594,0.177 0.896,0.385 0.302,0.208 10 true SST 1.073,0.771 1.281,0.99 0.208,0.219 10 false *a
*a Torque Wrench Fulcrum Length


Using SST, install the oil pressure sensor to the continuously variable transaxle assembly.

SST
09326-22011  

Torque:
Specified Tightening Torque : 20.6 N*m (210 kgf*cm, 15 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 50 mm (1.97 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)): 15.7 N*m (160 kgf*cm, 12 ft.*lbf)




c.

Connect the oil pressure sensor connector.


Hide 2.INSPECT FOR CONTINUOUSLY VARIABLE TRANSAXLE FLUID LEAK

Hide 51442C 3.INSTALL ENGINE UNDER COVER LH (w/o Metal Type Under Cover)

Hide 51405A 4.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)

Hide 51451A 5.INSTALL CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)

Hide 6.INSTALL FRONT WHEEL LH

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)