27060
1.REMOVE GENERATOR WITH REGULATOR ASSEMBLY
53141F
2.REMOVE RADIATOR COVER
89467B
3.REMOVE AIR FUEL RATIO SENSOR
17168
4.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
Remove the 3 bolts and No. 2 exhaust manifold heat insulator from the exhaust manifold converter sub-assembly.
17410
5.DISCONNECT FRONT EXHAUST PIPE ASSEMBLY
| *A | for CVT |
| *B | for Manual Transaxle |
Disconnect the heated oxygen sensor connector.
Disengage the clamp to disconnect the heated oxygen sensor wire from the wire harness clamp bracket.
Remove the 2 bolts and 2 compression springs to disconnect the front exhaust pipe assembly from the exhaust manifold converter sub-assembly.
17118
6.REMOVE MANIFOLD STAY
Remove the bolt, nut and manifold stay from the exhaust manifold converter sub-assembly and cylinder block sub-assembly.
25051
7.REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY
Remove the 5 nuts and exhaust manifold converter sub-assembly from the cylinder head sub-assembly.
Remove the exhaust manifold to head gasket from the cylinder head sub-assembly.
Remove the exhaust pipe gasket from the exhaust manifold converter sub-assembly.