Home › Engine / Hybrid System › 1NR-FE ENGINE CONTROL › ECM › 2016.04–2016.07
RM30M0E _51 Engine / Hybrid System _053310 1NR-FE ENGINE CONTROL _0260017 ECM A

1NR-FE ENGINE CONTROL  ECM  INSTALLATION  


PROCEDURE

Hide 89661 1.INSTALL ECM (for CVT)

a.

Engage the 3 guides to install the ECM to the ECM bracket.


b.

Install the ECM with ECM bracket to the vehicle with the 2 nuts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the ECM.



c.

Engage the clamp to connect the wire harness to the ECM bracket.


d.

Connect the 5 ECM connectors.


Hide 89661 2.INSTALL ECM (for Manual Transaxle)

a.

Engage the 3 guides to install the ECM to the ECM bracket.


b.

Install the ECM with ECM bracket to the vehicle with the 2 nuts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the ECM.



c.

Engage the clamp to connect the wire harness to the ECM bracket.


d.

Connect the 4 ECM connectors.


Hide 55550 3.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

Hide 5. PERFORM INITIALIZATION

·

Perform "reset memory", "deceleration sensor 0 point calibration", "CVT oil pressure calibration" after replacing the ECM.

Click hereDrivetrain>K411 CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION

·

Perform "Vehicle Identification Number (VIN) or frame number registration" after replacing the ECM.

Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION