Home › Engine / Hybrid System › 1NR-FE ENGINE CONTROL › CAMSHAFT POSITION SENSOR › from 2016.04
RM30M0E _51 Engine / Hybrid System _053310 1NR-FE ENGINE CONTROL _0260020 CAMSHAFT POSITION SENSOR A

1NR-FE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11101W 1.INSTALL CAMSHAFT POSITION SENSOR (for Intake Side)

a.
A158220

Apply a light coat of engine oil to the O-ring.

NOTICE:

If reusing the camshaft position sensor, be sure to inspect the O-ring.



b.

Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If a component has been dropped or subjected to a strong impact, replace the camshaft position sensor.

·

Make sure that the O-ring is not damaged or does not jump out of position during installation.




c.

Connect the camshaft position sensor connector.


Hide 11101W 2.INSTALL CAMSHAFT POSITION SENSOR (for Exhaust Side)

a.
A158220

Apply a light coat of engine oil to the O-ring.

NOTICE:

If reusing the camshaft position sensor, be sure to inspect the O-ring.



b.

Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If a component has been dropped or subjected to a strong impact, replace the camshaft position sensor.

·

Make sure that the O-ring is not damaged or does not jump out of position during installation.




c.

Connect the camshaft position sensor connector.