Home › Engine / Hybrid System › 1NR-FE ENGINE CONTROL › IGNITION COIL AND SPARK PLUG › from 2016.04
RM30M0E _51 Engine / Hybrid System _053310 1NR-FE ENGINE CONTROL _0260022 IGNITION COIL AND SPARK PLUG A

1NR-FE ENGINE CONTROL  IGNITION COIL AND SPARK PLUG  INSTALLATION  


PROCEDURE

Hide 19100P 1.INSTALL SPARK PLUG

a.

Using a 14 mm spark plug wrench, install the 4 spark plugs to the cylinder head sub-assembly.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the spark plug.


HINT:

Perform "Inspection After Repairs" after replacing the spark plug.

Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION



Hide 19500D 2.INSTALL NO. 1 IGNITION COIL

a.

Install the 4 No. 1 ignition coils to the cylinder head cover sub-assembly with the 4 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the No. 1 ignition coil.


HINT:
·

When assembling the No. 1 ignition coil to the cylinder head cover sub-assembly, press and continue to hold the No. 1 ignition coil so that it is fully inserted into the plug tube while tightening.

·

Perform "Inspection After Repairs" after replacing the No. 1 ignition coil.

Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION




b.

Connect the 4 No. 1 ignition coil connectors.


Hide 4.PERFORM INITIALIZATION

a.

Perform "Inspection After Repairs" after replacing the spark plug.

Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION