89615
1.INSTALL KNOCK SENSOR
Install the knock sensor to the cylinder block sub-assembly with the bolt as shown in the illustration.
If a component has been dropped or subjected to a strong impact, replace the knock sensor.
Make sure that the knock sensor is in the correct position.
Perform "Inspection After Repairs" after replacing the knock sensor.
Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION
Connect the knock sensor connector.
17111
2.INSTALL INTAKE MANIFOLD
3.PERFORM INITIALIZATION
Perform "Inspection After Repairs" after replacing the knock sensor.
Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION