Home › Engine / Hybrid System › 2NR-FE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE › from 2016.04
RM30M0E _51 Engine / Hybrid System _053304 2NR-FE ENGINE CONTROL _0260031 CAMSHAFT OIL CONTROL VALVE A

2NR-FE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  INSTALLATION  


PROCEDURE

Hide 15330A 1.INSTALL CAM TIMING OIL CONTROL VALVE O-RING

HINT:

This procedure is performed when the cam timing oil control valve O-ring must be replaced with a new one.


a.

Install a new cam timing oil control valve O-ring to the camshaft timing oil control valve assembly.

NOTICE:

Do not damage the cam timing oil control valve O-ring.



Hide 11101J 2.INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Intake Side)

a.
A198003

Apply a light coat of engine oil to the cam timing oil control valve O-ring and install it to the camshaft timing oil control valve assembly.

NOTICE:

Do not twist the cam timing oil control valve O-ring.



b.

Install the camshaft timing oil control valve assembly to the cylinder head cover sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

Do not allow foreign matter to contact the oil seal face of the camshaft timing oil control valve assembly (connecting surface with the cylinder head cover sub-assembly).

·

Make sure that the camshaft timing oil control valve assembly is not cracked or moved out of place when installing the camshaft timing oil control valve assembly.

·

If the camshaft timing oil control valve assembly has been struck or dropped, replace it.




c.

Connect the camshaft timing oil control valve assembly connector.


Hide 11101J 3.INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Exhaust Side)

a.
A198003

Apply a light coat of engine oil to the cam timing oil control valve O-ring and install it to the camshaft timing oil control valve assembly.

NOTICE:

Do not twist the cam timing oil control valve O-ring.



b.

Install the camshaft timing oil control valve assembly to the cylinder head cover sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

Do not allow foreign matter to contact the oil seal face of the camshaft timing oil control valve assembly (connecting surface with the cylinder head cover sub-assembly).

·

Make sure that the camshaft timing oil control valve assembly is not cracked or moved out of place when installing the camshaft timing oil control valve assembly.

·

If the camshaft timing oil control valve assembly has been struck or dropped, replace it.




c.

Connect the camshaft timing oil control valve assembly connector.


Hide 12611 5.INSTALL NO. 1 ENGINE COVER

a.

Engage the 2 front grommets, then the rear grommets to install the No. 1 engine cover to the cylinder head cover sub-assembly.

NOTICE:

Be sure to engage the grommets securely.