51441C
1.REMOVE ENGINE UNDER COVER RH (w/o Metal Type Under Cover)
51451A
2.REMOVE CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)
51405A
3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)
11301K
4.REMOVE CRANKSHAFT POSITION SENSOR
Disconnect the crankshaft position sensor connector.
Remove the bolt and crankshaft position sensor from the timing chain cover assembly.
If a component has been dropped or subjected to a strong impact, replace the crankshaft position sensor.