Home › Engine / Hybrid System › 2NR-FE ENGINE CONTROL › ATMOSPHERIC PRESSURE SENSOR › from 2016.04
RM30M0E _51 Engine / Hybrid System _053304 2NR-FE ENGINE CONTROL _0260042 ATMOSPHERIC PRESSURE SENSOR G

2NR-FE ENGINE CONTROL  ATMOSPHERIC PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT ATMOSPHERIC PRESSURE SENSOR

a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List / Atmosphere Pressure.

Powertrain > Engine and ECT > Data List
Tester Display
Atmosphere Pressure
50003 234 7

e.

Read the values displayed on the GTS.

OK:

Approximately the same as ambient atmospheric pressure


If the result is not as specified, replace the atmospheric pressure sensor.

HINT:
·

Standard atmospheric pressure is 101 kPa (abs) [758 mmHg (abs)].

·

For every 100 m (328 ft.) increase in altitude, pressure drops by 1 kPa (7.5 mmHg). This varies by weather.




f.

Remove the glove compartment door assembly.

Click here


g.

While applying a vacuum of 66.7 kPa (abs) [500 mmHg (abs)] to the atmospheric pressure sensor using a vacuum pump, read the values displayed on the GTS.

OK:

Approximately the same as ambient atmospheric pressure -66.7 kPa (abs) [500 mmHg (abs)]


If the result is not as specified, replace the atmospheric pressure sensor.

HINT:
·

Standard atmospheric pressure is 101 kPa (abs) [758 mmHg (abs)].

·

For every 100 m (328 ft.) increase in altitude, pressure drops by 1 kPa (7.5 mmHg). This varies by weather.




h.

Install the glove compartment door assembly.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>INSTALLATION