Home › Drivetrain › C50 MANUAL TRANSMISSION / TRANSAXLE › TRANSMISSION CONTROL CABLE(for 2NR-FE) › 2016.04–2016.07
RM30M0E _52 Drivetrain _017090 C50 MANUAL TRANSMISSION / TRANSAXLE _0261375 TRANSMISSION CONTROL CABLE(for 2NR-FE) A

C50 MANUAL TRANSMISSION / TRANSAXLE  TRANSMISSION CONTROL CABLE(for 2NR-FE)  REMOVAL  


PROCEDURE

Hide 12262 1.DISCONNECT NO. 2 VENTILATION HOSE

Hide 17880 2.REMOVE AIR CLEANER HOSE ASSEMBLY

Hide 17801 4.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 57533B 10.REMOVE FRONT FLOOR CENTER BRACE

Hide 17410 11.REMOVE FRONT EXHAUST PIPE ASSEMBLY

Hide 58151 12.REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR

a.
C294351

Remove the 2 bolts, nut and front No. 1 floor heat insulator from the body.


Hide 33820B 13.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

a.
C294352C01
0.594,1.25 0.802,1.063 false 1.427,3.094 1.792,2.615 true 2.365,3.156 2.656,2.708 true 1.281,3.021 1.594,3.177 0.313,0.156 10 false *1 2.219,3.094 2.531,3.25 0.313,0.156 10 false *2 0.427,1.177 0.74,1.333 0.313,0.156 10 false *3
*1 Clip A
*2 Clip B
*3 Nut
V100135

Rotate approximately 180°


Remove the clip A to disconnect the select cable end of the transmission control cable assembly from the floor shift shift lever assembly.


b.

Widen the clip B to disconnect the shift cable end of the transmission control cable assembly from the floor shift shift lever assembly.


c.

Rotate the 2 nuts of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, separate the transmission control cable assembly from the floor shift shift lever assembly.

NOTICE:

Do not rotate the nut excessively as it may damage the internal spring and transmission control cable assembly will not be reusable.



d.
C294354E01
0.927,1.115 1.063,1.302 0.135,0.188 10 true A 1.021,2.083 1.177,2.281 0.156,0.198 10 true A 2.292,0.375 2.448,0.552 0.156,0.177 10 true B 2.688,1.583 2.844,1.781 0.156,0.198 10 false B

Remove the 2 clips A and 2 washers to disconnect the transmission control cable assembly from the manual transaxle assembly.


e.

Remove the 2 clips B to separate the transmission control cable assembly from the floor shift control lever housing support bracket.


f.
C294355

Remove the 3 nuts and transmission control cable assembly from the body.