30400
1.REMOVE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY (for CVT)
30300
2.REMOVE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)
31210
3.REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle)
31250
4.REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle)
32101
5.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for CVT)
Using SST, hold the crankshaft pulley.
Remove the 8 bolts, rear drive plate spacer, drive plate and ring gear sub-assembly, and front drive plate spacer from the crankshaft.
13405
6.REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)
Using SST, hold the crankshaft pulley.
Remove the 8 bolts and flywheel sub-assembly from the crankshaft.
11401L
7.REMOVE REAR ENGINE OIL SEAL
| *a | Cut Position |
| *b | Protective Tape |
Using a knife, cut off the lip of the rear engine oil seal.
Using a screwdriver with its tip wrapped with protective tape, pry out the rear engine oil seal from the cylinder block sub-assembly and oil pan sub-assembly.
After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.