30300
1.REMOVE MANUAL TRANSAXLE ASSEMBLY
31204
2.REMOVE CLUTCH RELEASE FORK SUB-ASSEMBLY (for 2NR-FE)
| *1 | Release Fork Support |
| *2 | Clutch Release Fork Support Boot |
Disengage the clutch release fork support boot from the release fork support.
Remove the clutch release fork sub-assembly with the clutch release bearing assembly from the manual transaxle assembly.
31204
3.REMOVE CLUTCH RELEASE FORK SUB-ASSEMBLY (for 1NZ-FE)
| *1 | Release Fork Support |
| *2 | Release Fork Anti-rattle Spring |
Disengage the release fork anti-rattle spring from the release fork support.
Remove the clutch release fork sub-assembly with the clutch release bearing assembly from the manual transaxle assembly.
31230
4.REMOVE CLUTCH RELEASE BEARING ASSEMBLY
Disengage the release bearing hub clip and remove the clutch release bearing assembly from the clutch release fork sub-assembly.
31232A
5.REMOVE RELEASE BEARING HUB CLIP
| *1 | Release Bearing Hub Clip |
| *2 | Clutch Release Bearing Assembly |
Remove the release bearing hub clip from the clutch release bearing assembly.
31237
6.REMOVE CLUTCH RELEASE FORK SUPPORT BOOT (for 2NR-FE)
Remove the release fork anti-rattle spring from the clutch release fork sub-assembly.
Remove the clutch release fork support boot from the release fork anti-rattle spring.
31126
7.REMOVE CLUTCH RELEASE FORK BOOT
Remove the clutch release fork boot from the manual transaxle assembly.
31236B
8.REMOVE RELEASE FORK SUPPORT
Using a 19 mm deep socket wrench, remove the release fork support from the manual transaxle assembly.
31210
9.REMOVE CLUTCH COVER ASSEMBLY
| *a | Matchmark |
Put the matchmarks on the clutch cover assembly and flywheel sub-assembly.
Loosen each bolt one turn at a time until the spring tension is released.
Remove the 6 bolts and pull off the clutch cover assembly.
Do not drop the clutch disc assembly.
31250
10.REMOVE CLUTCH DISC ASSEMBLY
Remove the clutch disc assembly.
Keep the lining part of the clutch disc assembly, the pressure plate of the clutch cover assembly and the surfaces of the flywheel sub-assembly free of oil and foreign matter.