84450
1.INSTALL IGNITION OR STARTER SWITCH ASSEMBLY
Engage the 2 claws to install the ignition or starter switch assembly to the ignition switch lock cylinder and key set.
Perform this operation after situating the ignition switch lock cylinder and key set in such a way that the ignition or starter switch assembly faces upward, as shown in the illustration.
Do not turn the ignition switch lock cylinder and key set sideways or downward because doing so might release the ignition switch lock cylinder and key set's component parts.
69057A
2.INSTALL IGNITION SWITCH LOCK CYLINDER AND KEY SET (for LHD)
69057A
3.INSTALL IGNITION SWITCH LOCK CYLINDER AND KEY SET (for RHD)
4.INSTALL STEERING COLUMN ASSEMBLY (for LHD)
5.INSTALL STEERING COLUMN ASSEMBLY (for RHD)