1.CHECK ENGINE OIL LEVEL
Warm up and stop the engine, then wait for 5 minutes.
Check that the engine oil level is between the low level and full level marks on the engine oil level dipstick.
If the level is low, check for engine oil leaks and add engine oil to the full level mark.
Do not fill to above the full level mark.
A certain amount of engine oil will be consumed while driving. In the following situations, oil consumption may increase, and engine oil may need to be refilled in between oil maintenance intervals.
When the engine is new, for example directly after purchasing the vehicle or after replacing the engine.
If low quality oil or oil of an inappropriate viscosity is used.
When driving at high engine speed or with a heavy load (when towing), or when driving while accelerating or decelerating frequently.
When leaving the engine idling for a long time, or when driving frequently through heavy traffic.
When judging the amount of oil consumption, keep in mind that the oil may have become diluted, making it difficult to judge the true level accurately.
2.CHECK ENGINE OIL QUALITY
Check the engine oil for deterioration, water intrusion, discoloration or thinning.
If the quality is visibly poor, replace the engine oil.
3.CHECK ENGINE OIL PRESSURE
Remove the engine oil pressure switch assembly.
Click hereEngine / Hybrid System>2NR-FE LUBRICATION>OIL PRESSURE SWITCH>REMOVAL
Install the oil pressure gauge to the cylinder block sub-assembly.
Warm up the engine.
After warming up the engine, the engine coolant temperature is 75 to 100°C (167 to 212°F).
Inspect the engine oil pressure.
| At Idle | At 3000 rpm |
|---|---|
| 30 kPa (0.3 kgf/cm2, 4.4 psi) or more | 150 to 550 kPa (1.5 to 5.6 kgf/cm2, 22 to 80 psi) |
If the result is not as specified, check the quality of the engine oil and check the oil paths for clogging. Repair or replace if necessary. If the engine oil pressure is still not as specified, replace the timing chain cover assembly.
Replace the timing chain cover sub-assembly as the engine oil pump is built into the timing chain cover assembly.
Remove the oil pressure gauge from the cylinder block sub-assembly.
Install the engine oil pressure switch assembly.
Click hereEngine / Hybrid System>2NR-FE LUBRICATION>OIL PRESSURE SWITCH>INSTALLATION
Inspect for engine oil leak.
Click hereEngine / Hybrid System>2NR-FE LUBRICATION>OIL AND OIL FILTER>REPLACEMENT