Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › SFI SYSTEM(for Manual Transaxle) › 2016.04–2016.07
RM30M0E _51 Engine / Hybrid System _017071 1NZ-FE ENGINE CONTROL _0090158 SFI SYSTEM(for Manual Transaxle) L

1NZ-FE ENGINE CONTROL  SFI SYSTEM(for Manual Transaxle)  PRECAUTION  


INITIALIZATION


NOTICE:
·

If the ECM is replaced, register the ECU communication ID for Immobiliser System (refer to the registration procedures for Service Bulletin).

·

Perform initialization (throttle position) after replacing the throttle body with motor assembly or cleaning any throttle body with motor assembly components.

Click hereEngine / Hybrid System>1NZ-FE ENGINE CONTROL>THROTTLE BODY>INSTALLATION

·

Perform initialization (throttle position) after reconnecting the battery cable or replacing the ECM.

Click hereEngine / Hybrid System>1NZ-FE ENGINE CONTROL>THROTTLE BODY>INSTALLATION

·

When the cable is disconnected from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.

System Name See Procedure
Power Door Lock Control System (Click here)




WHEN USING GTS


CAUTION:

Observe the following items for safety reasons:


·

Before using the GTS, read the instruction manual.

·

Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.

·

When driving the vehicle for testing purposes using the GTS, 2 persons are required. One is for driving the vehicle, and the other operates the GTS.