Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
89170A
1.INSTALL AIRBAG ECU ASSEMBLY
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
| *a | Fulcrum Length |
Using SST, install the airbag ECU assembly with the 3 bolts.
Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
This torque value is effective when SST is parallel to a torque wrench.
If the airbag ECU assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
When installing the airbag ECU assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
When the ignition switch is first turned to ON after the airbag ECU assembly has been replaced, make sure that no one is in the vehicle.
| *1 | Lever |
| *2 | Waterproof Sheet |
Connect the connector holder and lock the lever.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Check that the waterproof sheet is properly set.
Check that there is no looseness in the installation parts of the airbag ECU assembly.
58910C
2.INSTALL REAR CONSOLE BOX ASSEMBLY (w/ Console Box Lid)
58910C
3.INSTALL REAR CONSOLE BOX ASSEMBLY (w/o Console Box Lid)
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. (for Hatchback)
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
5. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION (w/ VSC)
6.INSPECT SRS WARNING LIGHT