According to current from the ECM, the shift solenoid valve SLP controls primary pulley pressure in accordance with the requested gear ratio to perform gear ratio changes.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P2820 | Pressure Control Solenoid "J" Performance or Stuck Off | Either one of the following conditions is met (1 trip detection logic):
·
When the oil pressure sensor output is 0.4 MPa (4.1 kgf/cm2, 58 psi) or more and the target gear ratio is less than 1.0, the actual gear ratio is 2.0 or more for 2 seconds or more. ·
When the oil pressure sensor output is 0.4 MPa (4.1 kgf/cm2, 58 psi) or more and the target gear ratio is 2.0 or more, the actual gear ratio is less than 0.5 for 2 seconds or more. |
Continuously variable transaxle assembly (Shift solenoid valve SLP) | Comes on | DTC stored |
The ECM compares the actual gear ratio with the target gear ratio. When the actual gear ratio and target gear ratio are different, the ECM detects the malfunction, illuminates the MIL and stores this DTC.
Perform initialization after replacing any parts related to the continuously variable transaxle system.
Click hereDrivetrain>K312 CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION
Check that no DTCs are stored after performing initialization.
Click hereDrivetrain>K312 CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DTC CHECK / CLEAR
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs using the GTS.
If any DTCs other than P2820 are output, perform troubleshooting for those DTCs first.
| Result | Proceed to |
|---|---|
| Only DTC P2820 is output | A |
| DTC P2820 and other DTCs are output | B |
A
B
Replace the continuously variable transaxle assembly.
Click hereDrivetrain>K312 CVT>CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY>COMPONENTS
| Proceed to |
|---|
| NEXT |
NEXT