Home › Engine / Hybrid System › 1NZ-FE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL › 2016.07–2016.10
RM30M0E _51 Engine / Hybrid System _017073 1NZ-FE ENGINE MECHANICAL _0091004 REAR CRANKSHAFT OIL SEAL A

1NZ-FE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 32101 2.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

a.
A166739E01
2.63,1.619 2.935,1.773 0.304,0.155 10 SST 1.954,2.054 2.592,1.726 false

Using SST, hold the crankshaft damper sub-assembly.

SST
09960-10010  (09962-01000, 09963-01000)


b.
A278687

Remove the 6 bolts, the rear drive plate spacer, the drive plate and ring gear sub-assembly, and the front drive plate spacer from the crankshaft.


Hide 11401L 3.REMOVE REAR ENGINE OIL SEAL

A166928C01
2.927,0.677 2.177,1.156 true 2.969,0.563 3.281,0.719 0.313,0.156 10 false *a 1.021,0.594 1.333,0.75 0.313,0.156 10 false *b
*a Protective Tape
*b Cut Position


a.

Using a knife, cut off the lip of the rear engine oil seal.


b.

Using a screwdriver with its tip wrapped in protective tape, pry out the rear engine oil seal from the cylinder block sub-assembly and oil pan sub-assembly.

NOTICE:

After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.