Home › Drivetrain › U340E AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION CONTROL CABLE › 2016.07–2016.10
RM30M0E _52 Drivetrain _017087 U340E AUTOMATIC TRANSMISSION / TRANSAXLE _0090611 TRANSMISSION CONTROL CABLE A

U340E AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION CONTROL CABLE  REMOVAL  


PROCEDURE

Hide 57533B 3.REMOVE FRONT FLOOR CENTER BRACE

Hide 17410 4.REMOVE FRONT EXHAUST PIPE ASSEMBLY

Hide 58151 5.REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR

a.
C282052

Remove the 2 bolts, nut and front No. 1 floor heat insulator from the body.


Hide 33820B 6.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

NOTICE:

To prevent damage to the transmission control cable assembly and transmission floor shift assembly, disconnect the transmission floor shift assembly side of the transmission control cable assembly before disconnecting the automatic transaxle assembly side.


a.

Apply the parking brake and move the shift lever to N.


b.
C286312

Disconnect the end of the transmission control cable assembly from the transmission floor shift assembly.


c.
C286314C02
0.615,1.427 0.688,1.208 false 0.552,1.438 0.865,1.594 0.313,0.156 10 false *1
*1 Nut
V100135

Rotate approximately 180°
V100136

Pull out


Rotate the nut of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, separate the transmission control cable assembly from the transmission floor shift assembly.

NOTICE:

Rotating the nut too much will damage the internal spring, and the transmission control cable assembly will not be reusable. Do not turn the nut too far.



d.
C282050

Remove the nut to disconnect the transmission control cable assembly from the transmission control shaft lever.


e.

Remove the clip to separate the transmission control cable assembly from the No. 1 transmission control cable bracket.


f.
C282036

Separate the transmission control cable assembly from the transmission control cable support.


g.
C282044

Remove the 3 nuts and transmission control cable assembly from the body.


Hide 33829 7.REMOVE NO. 1 TRANSMISSION CONTROL CABLE SUPPORT

HINT:

Perform this procedure only when replacement of the No. 1 transmission control cable support is necessary.


a.
C282053

Remove the nut and No. 1 transmission control cable support from the body.