35148
1.INSTALL NO. 1 GOVERNOR APPLY GASKET
Apply a light coat of Toyota Genuine ATF Type T-IV to a new No. 1 governor apply gasket and install it to the automatic transaxle case sub-assembly.
35251
2.INSTALL CHECK BALL BODY
Install the check ball body compression spring and check ball body to the automatic transaxle case sub-assembly.
35410
3.INSTALL TRANSMISSION VALVE BODY ASSEMBLY
Connect the manual valve connecting rod to the manual valve lever sub-assembly.
Temporarily install the transmission valve body assembly to the automatic transaxle case sub-assembly with the 14 bolts.
Bolt length:
Bolt A: 20 mm (0.787 in.)
Bolt B: 28 mm (1.10 in.)
Bolt C: 36 mm (1.42 in.)
Bolt D: 40 mm (1.57 in.)
Bolt E: 49 mm (1.93 in.)
Tighten the 14 bolts.
82125J
4.CONNECT TRANSMISSION WIRE
Engage the 2 clamps, connect the 5 connectors and install the transmission wire to the transmission valve body assembly.
Engage the temperature sensor clamp and install the transmission wire to the transmission valve body assembly.
35330
5.INSTALL VALVE BODY OIL STRAINER ASSEMBLY
Apply a light coat of Toyota Genuine ATF Type T-IV to the gasket of the valve body oil strainer assembly.
Install the valve body oil strainer assembly to the transmission valve body assembly with the 3 bolts.
35394
6.INSTALL TRANSMISSION OIL CLEANER MAGNET
Install the 2 transmission oil cleaner magnets to the automatic transaxle oil pan sub-assembly as shown in the illustration.
35106D
7.INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY
Install a new automatic transaxle oil pan gasket and automatic transaxle oil pan sub-assembly to the automatic transaxle case sub-assembly with the 18 bolts.
Completely remove any oil or grease from the contact surfaces of the automatic transaxle case sub-assembly and the automatic transaxle oil pan sub-assembly with the automatic transaxle oil pan gasket before installation.
8.ADD AUTOMATIC TRANSAXLE FLUID
Pull out the transmission oil level dipstick sub-assembly from the transmission oil filler tube sub-assembly.
Add Toyota Genuine ATF Type T-IV through the transmission oil filler tube sub-assembly.
| Classification | Capacity
(Reference) |
|
|---|---|---|
| Toyota Genuine ATF Type T-IV | Dry fill | 5.6 liters (5.9 US qts, 4.9 Imp. qts) |
| Drain and refill | 2.0 liters (2.1 US qts, 1.8 Imp. qts) | |
9.INSPECT AUTOMATIC TRANSAXLE FLUID
10.INSPECT FOR AUTOMATIC TRANSAXLE FLUID LEAK
51442C
11.INSTALL ENGINE UNDER COVER LH