15100Q
1.INSTALL CRANKSHAFT POSITION SENSOR
Apply a light coat of engine oil to the O-ring.
If reusing the crankshaft position sensor, be sure to inspect the O-ring.
Install the crankshaft position sensor to the oil pump assembly with the bolt.
If a component has been dropped or subjected to a strong impact, replace the crankshaft position sensor.
Make sure that the O-ring is not damaged or does not jump out of position during installation.
Connect the crankshaft position sensor connector.
2.INSPECT FOR ENGINE OIL LEAK
51441C
3.INSTALL ENGINE UNDER COVER RH