1.DRAIN ENGINE COOLANT
11212
2.REMOVE NO. 2 CYLINDER HEAD COVER
23827A
3.DISCONNECT NO. 2 FUEL VAPOR FEED HOSE
Disconnect the No. 2 fuel vapor feed hose from the intake manifold.
23820
4.DISCONNECT FUEL VAPOR FEED HOSE ASSEMBLY
Disconnect the fuel vapor feed hose assembly from the clamp of the No. 1 air cleaner hose.
Loosen the 2 hose clips and disconnect the fuel vapor feed hose assembly from the No. 1 air cleaner hose and purge VSV.
17341T
5.DISCONNECT NO. 1 AIR HOSE
Loosen the hose clip and disconnect the No. 1 air hose from the No. 1 air cleaner hose.
17735
6.REMOVE AIR CLEANER CAP WITH NO. 1 AIR CLEANER HOSE
Disconnect the purge VSV connector and mass air flow meter connector.
Disengage the 3 clamps to disconnect the wire harness from the air cleaner cap and purge VSV.
| *a | Clamp |
| *b | Guide |
Loosen the hose clamp and disconnect the No. 1 air cleaner hose from the throttle body with motor assembly.
Disengage the 2 clamps to separate the air cleaner cap from the air cleaner case sub-assembly.
Disengage the 2 guides to remove the air cleaner cap with No. 1 air cleaner hose from the air cleaner case sub-assembly and throttle body with motor assembly.
16522
7.SEPARATE WATER FILLER BRACKET
Remove the 2 nuts to separate the water filler bracket from the throttle body with motor assembly.
16264
8.DISCONNECT NO. 2 WATER BY-PASS HOSE
Loosen the hose clip and disconnect the No. 2 water by-pass hose from the throttle body with motor assembly.
16261
9.DISCONNECT WATER BY-PASS HOSE
Loosen the hose clip and disconnect the water by-pass hose from the throttle body with motor assembly.
22030
10.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
Disengage the clamp to disconnect the wire harness from the wire harness clamp bracket.
Disconnect the throttle body with motor assembly connector.
Remove the nut and wire harness clamp bracket from the throttle body with motor assembly.
Remove the bolt, 3 nuts and throttle body with motor assembly from the intake manifold.
If a component has been dropped or subjected to a strong impact, replace the throttle body with motor assembly.
Remove the throttle body gasket from the intake manifold.