Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › ECM › 2016.07–2016.10
RM30M0E _51 Engine / Hybrid System _017071 1NZ-FE ENGINE CONTROL _0091207 ECM A

1NZ-FE ENGINE CONTROL  ECM  INSTALLATION  


PROCEDURE

Hide 89661 1.INSTALL ECM

a.

Engage the 3 guides to install the ECM to the ECM bracket.


b.

Install the ECM with ECM bracket to the vehicle with the 2 nuts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the ECM.



c.

Engage the clamp to connect the wire harness to the ECM bracket.


d.

Connect the 4 ECM connectors.


Hide 55550 2.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY