Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › 2016.07–2016.10
RM30M0E _51 Engine / Hybrid System _017071 1NZ-FE ENGINE CONTROL _0091211 CRANKSHAFT POSITION SENSOR A

1NZ-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 15100Q 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring.

NOTICE:

If reusing the crankshaft position sensor, be sure to inspect the O-ring.



b.

Install the crankshaft position sensor to the oil pump assembly with the bolt.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:
·

If a component has been dropped or subjected to a strong impact, replace the crankshaft position sensor.

·

Make sure that the O-ring is not damaged or does not jump out of position during installation.




c.

Connect the crankshaft position sensor connector.


Hide 51441C 3.INSTALL ENGINE UNDER COVER RH