Home › Drivetrain › C54 MANUAL TRANSMISSION / TRANSAXLE › TRANSMISSION CONTROL CABLE(for 2NZ-FE) › 2016.07–2016.10
RM30M0E _52 Drivetrain _017091 C54 MANUAL TRANSMISSION / TRANSAXLE _0094350 TRANSMISSION CONTROL CABLE(for 2NZ-FE) A

C54 MANUAL TRANSMISSION / TRANSAXLE  TRANSMISSION CONTROL CABLE(for 2NZ-FE)  REMOVAL  


PROCEDURE

Hide 74410 3.REMOVE BATTERY CARRIER ASSEMBLY

Hide 57533B 5.REMOVE FRONT FLOOR CENTER BRACE

Hide 17410 6.REMOVE FRONT EXHAUST PIPE ASSEMBLY

Hide 58151 7.REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR

a.
C282052

Remove the 2 bolts, nut and front No. 1 floor heat insulator from the body.


Hide 33820B 8.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

a.
C283110C02
0.573,1.198 0.792,1.042 false 2.333,3.115 2.667,2.688 true 1.385,3.042 1.802,2.625 true 1.24,2.958 1.552,3.115 0.313,0.156 10 false *1 2.177,3.031 2.49,3.188 0.313,0.156 10 false *2 0.417,1.104 0.729,1.26 0.313,0.156 10 false *3
*1 Clip A
*2 Clip B
*3 Nut
V100135

Rotate approximately 180°


Remove the clip A to disconnect the select cable end of the transmission control cable assembly from the floor shift shift lever assembly.


b.

Widen the clip B to disconnect the shift cable end of the transmission control cable assembly from the floor shift shift lever assembly.


c.

Rotate the 2 nuts of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, separate the transmission control cable assembly from the floor shift shift lever assembly.

NOTICE:

Do not rotate the nut excessively as it may damage the internal spring and the transmission control cable assembly will not be reusable.



d.
C283113E01
0.177,0.875 0.313,1.052 0.135,0.177 10 true A 2.063,1.583 2.198,1.76 0.135,0.177 10 true A 1.667,0.01 1.802,0.188 0.135,0.177 10 true B 2.771,1.063 2.906,1.24 0.135,0.177 10 true B

Remove the 2 clips A and 2 washers to disconnect the transmission control cable assembly from the floor shift selecting bellcrank assembly.


e.

Remove the 2 clips B to separate the transmission control cable assembly from the control cable bracket.


f.
C293440

Remove the 3 nuts and transmission control cable assembly from the body.


Hide 33829 9.REMOVE TRANSMISSION CONTROL CABLE SUPPORT

HINT:

Perform this procedure only when replacement of the transmission control cable support is necessary.


a.
C282053

Remove the nut and transmission control cable support from the body.