1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
55550
2.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
89661
3.REMOVE ECM (for CVT)
Disconnect the 5 ECM connectors.
Disengage the clamp to disconnect the wire harness from the ECM bracket.
Remove the 2 nuts and ECM with ECM bracket from the vehicle.
If a component has been dropped or subjected to a strong impact, replace the ECM.
Disengage the 3 guides to remove the ECM from the ECM bracket.
89661
4.REMOVE ECM (for Manual Transaxle)
Disconnect the 4 ECM connectors.
Disengage the clamp to disconnect the wire harness from the ECM bracket.
Remove the 2 nuts and ECM with ECM bracket from the vehicle.
If a component has been dropped or subjected to a strong impact, replace the ECM.
Disengage the 3 guides to remove the ECM from the ECM bracket.