Be sure that the ignition switch is off if you work near the electric cooling fans or radiator grille. With the ignition switch ON, the electric cooling fans may automatically start to run if the engine coolant temperature is high and/or the air conditioning is on (w/ air conditioning system).
81150
1.REMOVE HEADLIGHT ASSEMBLY LH (for Sedan)
81150
2.REMOVE HEADLIGHT ASSEMBLY RH (for Sedan)
Use the same procedure as for the LH side.
3.DRAIN ENGINE COOLANT
53510
4.REMOVE HOOD LOCK ASSEMBLY (for Sedan LHD)
53510
5.REMOVE HOOD LOCK ASSEMBLY (for Sedan RHD)
w/ Engine Hood Courtesy Switch :
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE HOOD COURTESY SWITCH>REMOVAL
w/o Engine Hood Courtesy Switch :
Click hereVehicle Exterior>DOOR / HATCH>HOOD LOCK CONTROL CABLE ASSEMBLY(for RHD)>REMOVAL
53510
6.REMOVE HOOD LOCK ASSEMBLY (for Hatchback LHD)
53510
7.REMOVE HOOD LOCK ASSEMBLY (for Hatchback RHD)
w/ Engine Hood Courtesy Switch :
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE HOOD COURTESY SWITCH>REMOVAL
w/o Engine Hood Courtesy Switch :
Click hereVehicle Exterior>DOOR / HATCH>HOOD LOCK CONTROL CABLE ASSEMBLY(for RHD)>REMOVAL
53215B
8.REMOVE HOOD LOCK SUPPORT (for Sedan)
Disengage the clamp to disconnect the wire harness from the hood lock support.
Remove the 2 bolts and hood lock support from the radiator support assembly.
53215B
9.REMOVE HOOD LOCK SUPPORT (for Hatchback)
Disengage the clamp to disconnect the wire harness from the hood lock support.
Remove the clip to separate the hood lock support from the front bumper assembly.
Remove the 2 bolts and hood lock support from the radiator support assembly.
88891H
10.REMOVE NO. 1 COOLER COVER (for Sedan)
88891H
11.REMOVE NO. 1 COOLER COVER (for Hatchback)
89173
12.REMOVE FRONT AIRBAG SENSOR (w/ Airbag System)
53216A
13.REMOVE UPPER RADIATOR SUPPORT
Disengage the clamp to separate the hood lock control cable assembly from the upper radiator support.
Disengage the 3 clamps to disconnect the wire harness from the upper radiator support.
Disconnect the low pitched horn assembly connector.
Remove the 4 bolts and upper radiator support from the radiator support assembly.
14.DISCONNECT RADIATOR RESERVOIR TANK HOSE
Disconnect the radiator reservoir tank hose from the radiator assembly.
16571C
15.DISCONNECT NO. 1 RADIATOR HOSE
Slide the hose clip and disconnect the No. 1 radiator hose from the radiator assembly.
16572D
16.DISCONNECT NO. 2 RADIATOR HOSE
Slide the hose clip and disconnect the No. 2 radiator hose from the radiator assembly.
16400
17.REMOVE RADIATOR ASSEMBLY (w/ Cooler System)
Disconnect the cooling fan motor connector.
Disengage the 3 clamps to disconnect the wire harness from the fan shroud.
Disengage the 2 claws and 2 guides to separate the cooler condenser assembly from the radiator assembly.
While tilting the cooler condenser assembly toward the front of the vehicle, separate the cooler condenser assembly from the radiator assembly.
Remove the radiator assembly together with fan shroud from the vehicle.
Do not apply excessive force to the cooler condenser assembly or piping when removing the radiator assembly.
16400
18.REMOVE RADIATOR ASSEMBLY (w/o Cooler System)
Disconnect the cooling fan motor connector.
Disengage the 3 clamps to disconnect the wire harness from the fan shroud.
Remove the radiator assembly together with fan shroud from the vehicle.
16711
19.REMOVE FAN SHROUD
Disengage the 2 claws and 3 guides to remove the fan shroud from the radiator assembly.
16523A
20.REMOVE RADIATOR SUPPORT CUSHION
Remove the 2 radiator support cushions from the radiator assembly.
16535
21.REMOVE LOWER RADIATOR SUPPORT
Remove the 2 lower radiator supports from the radiator assembly.
22.REMOVE RADIATOR DRAIN COCK PLUG
Remove the radiator drain cock plug from the radiator assembly.
Replace the O-ring if it is damaged.
16561
23.REMOVE NO. 1 RADIATOR TO SUPPORT SEAL
This procedure is only performed when replacing the No. 1 radiator to support seal with a new one.
Remove the No. 1 radiator to support seal for upper side from the radiator assembly.
Remove the No. 1 radiator to support seal for lower side from the radiator assembly.