AIR CONDITIONING AMPLIFIER ASSEMBLY
Check from the rear of the connector while it is connected to the air conditioning amplifier assembly.
| Terminal No.
(Symbol) |
Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| F3-1 (IG+) - F3-14 (GND) | G - W-B | Power source (IG) | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | |||
| F3-4 (LIN1) - F3-14 (GND) | BE - W-B | LIN communication signal | Ignition switch ON | Pulse generation |
| F3-5 (TAM) - F3-34 (SG-2) | BE - L | Ambient temperature sensor signal | Ignition switch ON at 25°C (77°F) | 1.35 to 1.75 V |
| F3-9 (PSW) - F3-14(GND) | P - W-B | Air conditioner pressure sensor signal | ·
Engine running ·
Refrigerant pressure normal ·
Blower switch: LO ·
A/C switch: On |
0.74 to 4.62 V |
·
Engine running ·
Refrigerant pressure abnormal (less than 196 kPa [2.0 kgf/cm2, 28 psi]) ·
Blower switch: LO ·
A/C switch: On |
Below 0.74 V | |||
·
Engine running ·
Refrigerant pressure abnormal (more than 3140 kPa [32.0 kgf/cm2, 455 psi]) ·
Blower switch: LO ·
A/C switch: On |
4.62 V or higher | |||
| F3-10 (S5-2) - F3-14 (GND) | W - W-B | Solar sensor power supply | Ignition switch ON | 4.5 to 5.5 V |
| F3-11 (TX+) - F3-14 (GND) | V - W-B | CAN communication signal | Ignition switch ON | Pulse generation |
| F3-12 (TX-) - F3-14 (GND) | W - W-B | CAN communication signal | Ignition switch ON | Pulse generation |
| F3-14 (GND) - Body ground | W-B - Body ground | Ground for main power supply | Always | Below 1 Ω |
| F3-15 (SG-1) - Body ground | P - Body ground | Ground for room temperature sensor | Always | Below 1 Ω |
| F3-20 (HR) - F3-14 (GND) | G - W-B | Blower motor relay operation signal | ·
Ignition switch ON ·
Blower switch: LO |
Below 1 V |
·
Ignition switch ON ·
Blower switch: Off |
11 to 14 V | |||
| F3-21 (B) - F3-14 (GND) | GR - W-B | Power source (Back-up) | Always | 11 to 14 V |
| F3-22 (BLW) - F3-14 (GND) | G - W-B | Blower motor speed control signal | ·
Ignition switch ON ·
Blower switch: LO |
Pulse generation
(See waveform 1) |
| F3-29 (TR) - F3-15 (SG-1) | L - P | Room temperature sensor signal | ·
Ignition switch ON ·
Cabin temperature: 25°C (77°F) |
1.8 to 2.2 V |
| F3-30 (S5-3) - F3-34 (SG-2) | LG - L | Power supply for air conditioner pressure sensor | Ignition switch ON | 4.75 to 5.25 V |
| F3-33 (TSD) - F3-14 (GND) | B - W-B | Solar sensor signal | ·
Ignition switch ON ·
Solar sensor subjected to electric light |
0.8 to 4.3 V |
·
Ignition switch ON ·
Solar sensor covered with a cloth |
Below 0.8 V | |||
| F3-34 (SG-2) - Body ground | L - Body ground | Ground for ambient temperature sensor and air conditioner pressure sensor | Always | Below 1 Ω |
| F3-36 (AC1) - F3-14 (GND) | L - W-B | Magnet clutch request signal | ·
Engine running ·
Blower switch: LO ·
A/C switch off |
11 to 14 V |
·
Engine running ·
Blower switch: LO ·
A/C switch: On (magnet clutch on) |
Below 1 V | |||
| z2-2 (BUS G) - Body ground | - | Ground for BUS IC | Always | Below 1 Ω |
| z2-3 (BUS) - z2-2 (BUS G) | - | LIN communication signal | Ignition switch ON | Pulse generation |
| z2-4 (B BUS) - z2-2 (BUS G) | - | Power supply for BUS IC | Always | 11 to 14 V |
| z2-5 (SGA) - Body ground | - | Ground for evaporator temperature sensor | Always | Below 1 Ω |
| z2-6 (TEA) - z2-5 (SGA) | - | Evaporator temperature sensor signal | ·
Ignition switch ON ·
Evaporator temperature: 0°C (32°F) |
2.0 to 2.4 V |
·
Ignition switch ON ·
Evaporator temperature: 15°C (59°F) |
1.4 to 1.8 V |
Waveform 1:
| Item | Content |
|---|---|
| Terminal No. | F3-22 (BLW) - F3-14 (GND) |
| Tool Setting | 1 V/DIV., 50 μs./DIV. |
| Vehicle Condition | ·
Ignition switch ON ·
Blower switch: LO |
AIR CONDITIONING CONTROL ASSEMBLY
Check from the rear of the connector while it is connected to the air conditioning control assembly.
| Terminal No.
(Symbol) |
Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| F4-2 (LIN1) - F4-5 (GND) | BE - W-B | LIN communication signal | Ignition switch ON | Pulse generation |
| F4-5 (GND) - Body ground | W-B - Body ground | Ground for air conditioning control assembly | Always | Below 1 Ω |
| F4-8 (IG+) - F4-5 (GND) | G - W-B | Power source (IG) | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V |
ECM
for 1NR-FE:
Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>SFI SYSTEM>TERMINALS OF ECM
for 2NR-FE:
Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>SFI SYSTEM>TERMINALS OF ECM