When the shift lever is in M, the shift range can be changed using the shift paddle switches. It is also possible to select the shift range when the vehicle is being driven with the shift lever in D by operating the shift paddle switches.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Primary.
| Tester Display |
|---|
| Sports Shift Up SW |
| Sports Shift Down SW |
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Sports Shift Up SW | Sport shift up switch status | OFF or ON | ·
ON: Shift lever held in "+" or "+" shift paddle switch pulled ·
OFF: Shift lever not held in "+" or "+" shift paddle switch released |
- |
| Sports Shift Down SW | Sport shift down switch status | OFF or ON | ·
ON: Shift lever held in "-" or "-" shift paddle switch pulled ·
OFF: Shift lever not held in "-" or "-" shift paddle switch released |
- |
| Result | Proceed to |
|---|---|
| Data List values are normal | A |
| Data List values are not normal | B |
A
Click hereDrivetrain>K312 CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>CHECK FOR INTERMITTENT PROBLEMS
B
Disconnect the B48 and F130 ECM connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B48-17 (SFTU) - F130-21 (ECCS) | "+" continuously pulled | Below 3 Ω |
| B48-17 (SFTU) - F130-21 (ECCS) | Released | 1 MΩ or higher |
| B48-27 (SFTD) - F130-21 (ECCS) | "-" continuously pulled | Below 3 Ω |
| B48-27 (SFTD) - F130-21 (ECCS) | Released | 1 MΩ or higher |
Connect the B48 and F130 ECM connectors.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the B46 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B46-3 (E1) - Body ground | Always | Below 1 Ω |
Connect the B46 ECM connector.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereDrivetrain>K312 CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>Transmission Control Switch Circuit
NG
Disconnect the F143 spiral cable sub-assembly connector.
Disconnect the B48 and F130 ECM connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B48-27 (SFTD) - F143-7 (SDN) | Always | Below 1 Ω |
| B48-27 (SFTD) or F143-7 (SDN) - Body ground and other terminals | Always | 10 kΩ or higher |
| B48-17 (SFTU) - F143-14 (SUP) | Always | Below 1 Ω |
| B48-17 (SFTU) or F143-14 (SUP) - Body ground and other terminals | Always | 10 kΩ or higher |
| F130-21 (ECCS) - F143-2 (ECC) | Always | Below 1 Ω |
| F130-21 (ECCS) or F143-2 (ECC) - Body ground and other terminals | Always | 10 kΩ or higher |
Connect the B48 and F130 ECM connectors.
Connect the F143 spiral cable sub-assembly connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Spiral Cable Sub-assembly) |
Disconnect the steering pad switch assembly connector from the spiral cable sub-assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| z10-6 (SUP) - z10-7 (ECC) | "+" continuously pulled | Below 3 Ω |
| z10-6 (SUP) - z10-7 (ECC) | Released | 1 MΩ or higher |
| z10-12 (SDN) - z10-7 (ECC) | "-" continuously pulled | Below 3 Ω |
| z10-12 (SDN) - z10-7 (ECC) | Released | 1 MΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the connectors from the spiral cable sub-assembly.
| *a | Component without harness connected
(Spiral Cable Sub-assembly) |
*b | Steering Pad Switch Side |
| *c | Vehicle Side | - | - |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| z10-7 (ECC) - F143-2 (ECC) | Always | Below 3 Ω |
| z10-6 (SUP) - F143-14 (SUP) | Always | Below 3 Ω |
| z10-12 (SDN) - F143-7 (SDN) | Always | Below 3 Ω |
| z10-7 (ECC) or F143-2 (ECC) - Body ground and other terminals | Always | 10 kΩ or higher |
| z10-6 (SUP) or F143-14 (SUP) - Body ground and other terminals | Always | 10 kΩ or higher |
| z10-12 (SDN) or F143-7 (SDN) - Body ground and other terminals | Always | 10 kΩ or higher |
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for TMT Made) | B |
| NG (for TMMIN Made) | C |
A
B
C
Replace the ECM.
Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>ECM>COMPONENTS
| Proceed to |
|---|
| NEXT |
NEXT
| *a | Component without harness connected
(Shift Paddle Switch LH) |
| *b | Component without harness connected
(Shift Paddle Switch RH) |
Disconnect the A shift paddle switch RH connector and B shift paddle switch LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B-3 (ECC) - B-2 (SFTD) | "-" continuously pulled | Below 3 Ω |
| B-3 (ECC) - B-2 (SFTD) | Released | 1 MΩ or higher |
| B-4 (ECC1) - B-2 (SFTD) | "-" continuously pulled | Below 3 Ω |
| B-4 (ECC1) - B-2 (SFTD) | Released | 1 MΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-3 (SFTU) - A-2 (ECC1) | "+" continuously pulled | Below 3 Ω |
| A-3 (SFTU) - A-2 (ECC1) | Released | 1 MΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Steering Pad Switch Assembly Connector) |
Connect the A shift paddle switch RH connector and B shift paddle switch LH connector.
Disconnect the z12 No. 1 switch wire connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| z12-2 (SFTU) - z12-7 (ECC) | "+" continuously pulled | Below 3 Ω |
| z12-2 (SFTU) - z12-7 (ECC) | Released | 1 MΩ or higher |
| z12-3 (SFTD) - z12-7 (ECC) | "-" continuously pulled | Below 3 Ω |
| z12-3 (SFTD) - z12-7 (ECC) | Released | 1 MΩ or higher |
| Result | Proceed to |
|---|---|
| OK (for TMT Made) | A |
| OK (for TMMIN Made) | B |
| NG | C |
A
B
C