The cruise control system uses the same vehicle speed signal that is sent to the ECM for the SFI system. If DTC P0500 is detected, perform diagnosis using the inspection procedure for DTC P0500 in the SFI system. The speed signal is converted for use by the cruise control inside the ECM. Both the SFI system and the cruise control system can set DTC P0500, however, the detection conditions of the two systems are different.
for 1NR-FE:
Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>SFI SYSTEM>P0500
for 2NR-FE:
Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>SFI SYSTEM>P0500
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P0500 | Vehicle Speed Sensor Malfunction | While vehicle is being driven, no vehicle speed sensor signal is sent to the ECM. | ·
Open or short in speed signal circuit ·
Combination meter assembly ·
Skid control ECU (Brake actuator assembly) ·
ECM |
Refer to SFI System.
for 1NR-FE:
Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>SFI SYSTEM>P0500
for 2NR-FE:
Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>SFI SYSTEM>P0500
This DTC may be output by the SFI system at the same time. In that case, perform troubleshooting for the SFI system first.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
Perform the following to make sure that the DTC detection conditions are met.
If the detection conditions are not met, the malfunction cannot be detected.
Drive the vehicle for more than 10 seconds when the engine coolant temperature is more than 20°C (68°F).
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC P0500 is output (for 1NR-FE) | B |
| DTC P0500 is output (for 2NR-FE) | C |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
C
Click hereEngine / Hybrid System>2NR-FE ENGINE CONTROL>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING