The procedure described below is for the LH side. Use the same procedure for both the LH and RH side, unless otherwise specified.
67492A
1.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
74220
2.REMOVE FRONT DOOR ARMREST ASSEMBLY LH (for TMT Made)
74232
3.REMOVE FRONT ARMREST BASE UPPER PANEL LH (for TMMIN Made)
74232
4.REMOVE FRONT ARMREST BASE UPPER PANEL LH (for TMT Made)
67602
5.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (for TMMIN Made)
67602
6.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (for TMT Made)
67832
7.REMOVE FRONT DOOR SERVICE HOLE COVER LH
69217F
8.REMOVE FRONT DOOR OUTSIDE HANDLE COVER LH
| *1 | Hole Plug |
Remove the hole plug.
Using a T30 "TORX" socket wrench, loosen the screw.
Remove the front door outside handle cover LH with lock cylinder.
69220
9.REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH
for TMMIN Made:
Disconnect the connector.
Remove the front door outside handle assembly LH in the direction indicated by the arrow as shown in the illustration.
for TMT Made:
| *a | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, disengage the claws to open the cover as shown in the illustration.
| *a | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, disconnect the connector.
Remove the front door outside handle assembly in the direction indicated by the arrow as shown in the illustration.