Home › Vehicle Exterior › DOOR / HATCH › FRONT DOOR(for TMT Made) › 2017.10–2018.01
RM30M0E _59 Vehicle Exterior _017122 DOOR / HATCH _0335794 FRONT DOOR(for TMT Made) A

DOOR / HATCH  FRONT DOOR(for TMT Made)  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the LH and RH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Power Window)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (for Hatchback).

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 67492A 3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

a.
B346702

Disengage the 2 clips and remove the front door lower frame bracket garnish.


Hide 74220 4.REMOVE FRONT ARMREST ASSEMBLY

a.
B488387

Disengage the 8 claws, 3 clips and 4 guides.

HINT:

Disengage in order from the front of the vehicle.



b.
B488388C01
2.677,1.104 2.479,1.292 false 2.719,0.969 3.031,1.125 0.313,0.156 10 false *1
*1 Retainer


Disengage the retainer to remove the front armrest assembly.


Hide 74232 5.REMOVE FRONT ARMREST BASE UPPER PANEL

a.
B488389

Disengage the 8 claws, 2 clips and 4 guides.

HINT:

Disengage in order from the rear of the vehicle.



b.

for Driver Side:

i.
B488390

Disconnect the 2 connectors and remove the front armrest base upper panel.



c.

for Front Passenger Side:

i.
B488391

Disconnect the connector and remove the front armrest base upper panel.



Hide 67602 6.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

a.
B488392C01
1.344,0.844 1.698,0.688 true 1.74,0.573 2.052,0.771 0.313,0.198 10 false *a
*a Protective Tape


Using a screwdriver with its tip wrapped in protective tape, disengage the claw and open the door inside handle bezel plug.


b.
B488393

Remove the 3 screws.


c.
B488394

Disengage the 8 clips.


d.

Disengage the guide and the 5 claws.


e.
B488395C01
1.26,0.646 1.052,0.323 false 0.854,1.188 1.177,0.906 true 0.875,0.219 1.188,0.375 0.313,0.156 10 false *1 0.646,1.115 0.958,1.271 0.313,0.156 10 false *2
*1 Front Door Inside Locking Cable Assembly
*2 Front Door Lock Remote Control Cable Assembly


Disengage the 2 guides, disconnect the front door lock remote control cable assembly and front door inside locking cable assembly and remove the front door trim board sub-assembly.


Hide 69206B 7.REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY

a.
B488396

Disengage the 4 guides and remove the front door inside handle sub-assembly from the front door trim board sub-assembly.


Hide 86160 8.REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

Hide 87940 9.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY

Hide 68210C 10.REMOVE FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY

Hide 75756C 11.REMOVE FRONT DOOR WINDOW FRAME REAR MOULDING

Hide 75922M 12.REMOVE NO. 1 BLACK OUT TAPE (w/ Black Out Tape)

Hide 68172A 13.REMOVE FRONT DOOR GLASS INNER WEATHERSTRIP

a.
B488397

Remove the front door glass inner weatherstrip.


Hide 67832 14.REMOVE FRONT DOOR SERVICE HOLE COVER

a.
B488398

Remove the front door service hole cover.

HINT:

Remove any butyl tape remaining on the front door panel side.



Hide 68102 15.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

a.

Connect the power window regulator master switch assembly.


b.

Connect the cable to the negative (-) battery terminal.


c.

Move the front door glass sub-assembly so that the door glass bolts can be seen.


d.

Disconnect the cable from the negative (-) battery terminal.


e.

Disconnect the power window regulator master switch assembly.


f.
B346714

Remove the 2 bolts.

NOTICE:

Do not damage the front door glass sub-assembly.



g.
B346715E01
0.958,0.198 1.417,0.396 0.458,0.198 10 false (1) 2.094,0.26 2.552,0.458 0.458,0.198 10 false (2)

Remove the front door glass sub-assembly as indicated by the arrows in the order shown in the illustration.

NOTICE:

Do not damage the front door glass sub-assembly.



Hide 68151D 16.REMOVE FRONT DOOR GLASS RUN

a.
B488399

Remove the front door glass run.


Hide 67664C 17.REMOVE DOOR FRAME GARNISH

a.
B356959

Disengage the clamp and remove the door frame garnish.


Hide 69820 18.REMOVE FRONT DOOR WINDOW REGULATOR ASSEMBLY

a.
B488400C01
2.031,0.354 1.719,0.135 true 1.521,0.01 1.833,0.167 0.313,0.156 10 false *a
*a Temporary Bolt


Disconnect the connector.


b.

Loosen the temporary bolt.

NOTICE:

Do not remove the temporary bolt. If the temporary bolt is removed, the front door window regulator assembly may fall and cause damage.



c.

Remove the 5 bolts and the front door window regulator assembly.


d.

Remove the temporary bolt from the front door window regulator assembly.


Hide 67924 19.REMOVE FRONT DOOR NO. 2 STIFFENER CUSHION

a.
B346717C01
1.979,0.833 2.313,0.833 true 2.375,0.74 2.688,0.938 0.313,0.198 10 true *a
*a Double-sided Tape


Remove the 2 bolts.


b.

Peel off the double-sided tape and remove the front door No. 2 stiffener cushion.

HINT:

Remove any double-sided tape remaining on the front door panel side.



Hide 67404F 20.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

a.
B346718

Remove the 2 bolts.


b.

Disengage the guide and remove the front door rear lower frame sub-assembly.


Hide 69217F 21.REMOVE FRONT DOOR OUTSIDE HANDLE COVER (w/ Lock Cylinder)

a.
B488401C01
2.479,1.917 2.813,1.917 false 2.281,1.813 2.594,1.969 0.313,0.156 10 false *1
*1 Hole Plug


Remove the hole plug.


b.

Using a T30 "TORX" socket wrench, loosen the screw and remove the front door outside handle cover with lock cylinder.


c.
B470649

Disengage the claw and guide to remove the front door outside handle cover from the lock cylinder.


Hide 69217F 22.REMOVE FRONT DOOR OUTSIDE HANDLE COVER (w/o Lock Cylinder)

a.
B488402C01
0.625,2.063 0.958,2.063 false 1.01,1.969 1.323,2.125 0.313,0.156 10 false *1
*1 Hole Plug


Remove the hole plug.


b.

Using a T30 "TORX" socket wrench, loosen the screw.


c.

Disengage the 2 claws and remove the front door outside handle cover.


Hide 69320 23.REMOVE FRONT DOOR LOCK ASSEMBLY

Hide 69220 24.REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY (for Driver Side)

a.

w/ Smart Entry and Start System:

i.
B488403C01
1.458,1.313 2.063,1.938 true 2.135,1.854 2.448,2.01 0.313,0.156 10 false *a
*a Protective Tape


Using a screwdriver with its tip wrapped in protective tape, disengage the claws to open the cover as shown in the illustration.


ii.
B488404C01
1.615,1.188 0.844,1.896 true 0.635,1.792 0.948,1.948 0.313,0.156 10 false *a
*a Protective Tape


Using a screwdriver with its tip wrapped in protective tape, disconnect the connector.



b.
B488405

Remove the front door outside handle assembly in the direction indicated by the arrow as shown in the illustration.


Hide 69220 25.REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY (for Front Passenger Side)

a.
B488406

Remove the front door outside handle assembly in the direction indicated by the arrow as shown in the illustration.


Hide 69241H 26.REMOVE FRONT DOOR OUTSIDE HANDLE FRONT PAD

a.
B488407

Disengage the 2 claws and guide to remove the front door outside handle front pad.


Hide 69242E 27.REMOVE FRONT DOOR OUTSIDE HANDLE REAR PAD

a.
B488408

Disengage the 2 guides to remove the front door outside handle rear pad.


Hide 69202A 28.REMOVE FRONT DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY (for Driver Side)

a.

w/ Smart Entry and Start System:

i.
B488409C01
1.365,1.573 1.292,1.844 true 2.042,0.656 1.813,0.875 true 0.417,0.313 0.26,0.802 true 1.188,1.844 1.5,2 0.313,0.156 10 false *a 0.458,0.208 0.677,0.396 0.219,0.188 10 false *b 2.073,0.552 2.385,0.708 0.313,0.156 10 false *c
*a Clamp
*b Guide
*c Grommet


Using a clip remover, disengage the clamp.


ii.

Using a T30 "TORX" socket wrench, loosen the screw.


iii.

Disengage the grommet and guide to disconnect the front door outside handle frame sub-assembly with wire harness in the direction indicated by the arrow as shown in the illustration.


iv.
B488410C01
2.417,1.625 2.74,1.396 false 0.448,1.531 0.771,1.302 true 1.698,1.646 1.531,1.375 true 2.229,1.521 2.542,1.677 0.313,0.156 10 false *a 1.74,1.552 2.052,1.708 0.313,0.156 10 false *b 0.271,1.417 0.583,1.573 0.313,0.156 10 false *a
*a Clamp
*b Guide


Disengage the 2 clamps and guide to remove the front door outside handle frame sub-assembly.



b.

w/o Smart Entry and Start System:

i.
B470660C02
0.271,1.24 0.438,0.99 true 1.948,1.313 1.844,1.063 true 0.083,1.177 0.25,1.354 0.167,0.177 10 true *b 1.958,1.333 2.125,1.51 0.167,0.177 10 false *a
*a Grommet
*b Guide


Using a T30 "TORX" socket wrench, loosen the screw.


ii.

Disengage the grommet and guide to remove the front door outside handle frame sub-assembly in the direction indicated by the arrow as shown in the illustration.



Hide 69202A 29.REMOVE FRONT DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY (for Front Passenger Side)

a.
B470659C01
1.854,1.219 1.719,1.073 true 3.135,1.354 3,1.01 true 1.875,1.219 2.188,1.417 0.313,0.198 10 false *a 3.167,1.396 3.354,1.573 0.188,0.177 10 true *b
*a Grommet
*b Guide


Using a T30 "TORX" socket wrench, loosen the screw.


b.

Disengage the guide and remove the front door outside handle frame sub-assembly in the direction indicated by the arrow as shown in the illustration.


Hide 69312 30.REMOVE FRONT DOOR LOCK OPEN ROD

a.
B488413C01
2.813,2.198 2.521,1.948 true 1.688,1.99 1.427,1.917 true 2.333,1.823 2.646,1.979 0.313,0.156 10 false *a 1.229,1.792 1.542,1.948 0.313,0.156 10 false *a
*a Snap Ring


Disengage the snap ring as shown in the illustration.


b.

Remove the front door lock open rod from the front door handle frame sub-assembly.


Hide 67001A 31.REMOVE FRONT DOOR PANEL CUSHION

a.
B346729

Remove the 2 front door panel cushions.


Hide 68610 32.REMOVE FRONT DOOR CHECK ASSEMBLY

a.
B346730

Remove the 3 bolts and the front door check assembly.


Hide 67862 33.REMOVE FRONT DOOR WEATHERSTRIP

a.
B369423E01
0.667,1.417 0.313,1.115 true 0.74,1.406 0.906,1.594 0.167,0.188 10 true A

Using a clip remover, remove the clip.


b.

Using a clip remover, disengage the clip A and 14 clips and remove the front door weatherstrip.


Hide 75792 34.REMOVE DOOR WINDOW FRAME MOULDING CLIP

a.
B488414

Using a clip remover, disengage the claw to remove the door window frame moulding clip.


Hide 67837B 35.REMOVE FRONT DOOR DUST PROOF SEAL

a.
B488415

Disengage the 3 claws to remove the 3 front door dust proof seals.